The cable belt is designed for the transport of loose materials with small lumps such as sand, ash, gravel, etc. The belt core consists of steel cord plies and the covering layers are made of abrasion-resistant rubber. On the belt edge there are vulcanized rubber guide pins.
Nominal belt width (b)
Total belt width (M)
Width between pin centres (J)
700
794 mm
737 mm
850
959 mm
902 mm
Packaging:
CABLE-BELT conveyor belts are wound on wooden drums with side walls limiting the belt width. The roll is tied with a steel tape in 2-3 places depending on the belt width. Underneath the joints of the steel tape there are rubber pads so that the belt does not get damaged during transport.
Section through a rubber push element:
Rubber foil AA type s = 4 mm
Fleximat
* w = 762 mm
* w = 927 mm
Rubber foil; w = 6 mm
Side pins – type AA compound
Compound
Basic mechanical and physical properties
Hardness ShA
Tensile-Strength Mpa
Elongation %
Density g / cm3
Permanent pressure deformation (7 dg C) / 24 h %
1) Rubber foil „AA“; s = 4 mm
60 +/- 5
18
min. 400
1,12
max. 25
3) Rubber foil; s= 6 mm
68 +/- 5
5 až 7
min. 170
1,39
max. 40
2) Fleximat
ad. 2a) BF 4 x 0,6 / 0,8 MF / 3,5 / 762
ad. 2b) BF 4 x 0,71 / 0,8 MF / 4 / 927
Company HASIT Šumavské vápenice a omítkárny, Velké Hydčice
